Landayan, Akhmad Zulfikar (2015) PROTOTYPE SUPERVISORY CONTROL AND DATA ACQUISITION (SCADA) PADA PROSES MIXING GYPSUM DENGAN MENGGUNAKAN PID. Diploma thesis, POLITEKNIK PERKAPALAN NEGERI SURABAYA.
Full text not available from this repository.Abstract
ABSTRAK Proses mixing gypsum merupakan proses pencampuran bahan dasar pembuatan papan gypsum/ethernit. Bahan-bahan dasar pembuatan berupa semen, air, pasir. Proses yang terjadi di dalamnya yang pertama penimbangan bahan. Bahan-bahan tersebut harus dalam takaran komposisi yang tepat secara kuantitas. Setelah bahan ditimbang, semua bahan masuk ke tangki pengadukan untuk proses kedua yaitu mixing. Dengan sistem dan peralatan pembuatan gypsum secara manual, memungkinkan adanya takaran bahan yang kurang tepat.. Dengan adanya permasalahan di atas maka peneliti berusaha membuat sistem proses mixing gypsum berbasis Supevisory Control And Data Acquisition (SCADA). Sistem tersebut akan menggunakan sensor load cell untuk menimbang takaran bahan dengan tepat. Aktuator motor DC untuk memasukkan bahan ke dalam tangki penimbangan, dan valve untuk mengurangi bahan apabila takaran berlebihan. PLC digunakan sebagai kontroller yang akan memroses sistem. Tampilan SCADA memungkinkan mengontrol dan memonitoring proses yang yang sedang dilakukan. Hasil dari adanya sistem Supevisory Control And Data Acquisition pada proses mixing gypsum menggunakan PID adalah sistem pada tangki penimbangan material dengan kontrol valve yang dapat menjaga berat takaran pada tangki penimbangan. Dalam penjagaan takaran menggunakan PID didapatkan nilai Kp = 50 Ki = 150 dan Kd = 0. Kata kunci : PLC, SCADA, gypsum, mixing, load cell . ABSTRACT Gypsum mixing process is a process of the manufacture mixing of gypsum board or ethernit. Basic materials of manufacture such as cement, water, sand. Process that occur in it that first weighing the material. These materials must be in the proper dosage composition in quantity . Once the materials were weighed, all the ingredients into the mixing tank to a second process that is mixing. With systems and equipment manufacture gypsum manually, allowing the materials that are less precise dosing. According to the problem, researcher sought to create a system of gypsum-mixing process based on Supevisory Control And Data Acquisition (SCADA). The system will use the sensor load cell for weighing the materials with the right dose. DC motor actuators to incorporate the material into the weighing tank, and a valve to reduce the material if excessive doses. PLC is used as a controller that will process the system. SCADA display allows control and monitoring process is being carried out. Results of Supervisory Control And Data Acquisition on gypsum mixing process system using PID is a tank weighing systems on material with a control valve that can maintain dose of tank weighing. In the maintain dose using the PID values obtained Kp = 50 Ki = 150 and Kd = 0. Keywords: PLC, SCADA, gypsum, mixing, load cell.
| Item Type: | Thesis (Diploma) |
|---|---|
| Subjects: | T Technology > T Technology (General) |
| Divisions: | Jurusan Teknik Kelistrikan Kapal > D4 Teknik Otomasi |
| Depositing User: | Unnamed user with email repository@ppns.ac.id |
| Date Deposited: | 08 Sep 2018 04:18 |
| Last Modified: | 08 Sep 2018 04:18 |
| URI: | http://repository.ppns.ac.id/id/eprint/433 |
Actions (login required)
 |
View Item |
